Allan's Project - Coupester.com


1969 Mustang Mach 1

Replacing Body Panels Continued

There is a lot of work involved in this 69 Mach 1 Mustang build. As you seen on the previous page the body panels were getting installed. But I'm going to take one step backward before I go on. In the first picture here you will see that Allan is replacing a inner wheel well and, of course, it had to be done before the quarter panel could be installed.

The next picture is another angle of the quarter panel after it was set in place.

Now, moving forward again we move on to the next 2 pictures. Here the panel at the rear of the Mustang where the tail lights are has been removed. Once again you can see the angle iron that was used for make sure that the panel went back in the correct spot and lined up correctly. Allan then rested the tail light panel in place to get a idea of where he needed to go from there. To get a look at how it looked after the tail light panel was install you can jump forward two pages. (click next twice)

The last picture in this update is of the 69 Mach 1 outside the shop were Allan can start the fitting of the front fenders.

< Prev | Next >












This Project
Click Gallery
Partners
Coupester.com

Top ^